go back

Action Web Spray

€196.19 incl VAT

€159.50 excl VAT

Action Web Spray is a general purpose fast drying, sprayable contact adhesive available in a 22 litre canister. Read more

Quantity

Quantity:

- +

Add to Cart

This product is currently out of stock

Description Applications Directions for Use

Description

Action Web Spray is a general purpose fast drying, sprayable contact adhesive available in a 22 litre canister.

Action Web Spray adhesive is suitable for bonding a wide variety of materials to sheet timber, metal, EPDM rubber and some hard plastics. It will bond foams, fabrics, and other fibrous materials. This is a fast drying sprayable contact adhesive. It has good heat resistance and easy application control. This is a portable system with no pressurized air required. The spray system requires very little additional equipment and needs minimal cleaning of equipment.

Applications

Bonding PVC high pressure laminates to plywood, MDF, chipboard etc
Bonding EPDM in a roofing application
Gluing sheet metal (pvc coated steel, aluminum, powder/ painted steel)
Shopfitting and joinery applications

Directions for Use

This product is designed to be applied to two surfaces to be bonded together. Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc. For best results, the temperature of the adhesive and the surfaces being bonded should be between 60 degrees F – 80 degrees F (16degrees C – 27 degrees C).
Use with adequate ventilation. When possible we recommend shaking the canister well before using. Attach and secure hose tightly onto the spray gun with required tip. Attach the other end of the hose onto the canister. Make sure the hose-valve connections are securely tight. Open the valve on the canister slowly and fully, check for leaks during this process. Unlock the trigger on the spray gun to start spraying.
Prior to use, Check compatibility by spraying a small test patch of the adhesive on the substrate. This product may degrade some substrates. Spray about 10-20 cm (4” – 8”) away at a 90 degree angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100% coverage of the surface. If necessary, spray another coat of adhesive in areas that appear to need more adhesive. Spray both surfaces to be bonded, one surface vertically and the other surface horizontally. Allow the adhesive to tack off until no adhesive transfers to the knuckle when touched.
Adhere surfaces and press together with adequate pressure. A roller is recommended to apply a uniform pressure to achieve maximum strength. Allow 24 hours for the adhesive to fully cure.
If the spray tip clogs, unscrew the spray tip from the gun and clean with solvent such as lacquer thinner or acetone. Do not use a pin on the spray tip orifice.

Action Web Spray

You may also need...